Transfer Instructions

DTF-

A heat press is required. Confirm that your garment or fabric is compatible with the transfer and application temperature.

  1. Prepress the garment for 5–10 seconds to remove moisture and wrinkles.
  2. Place the transfer printed side up and the carrier film against the garment. Cover it with parchment paper or a protective sheet.
  3. Press at 300°F–320°F for 10–15 seconds using medium to firm pressure.
  4. Allow the transfer to cool completely before slowly peeling away the carrier film.
  5. Cover the design again with parchment paper and repress for 5–10 seconds to help secure the transfer.

UV DTF-

Apply to a clean, dry, smooth surface. Surface coatings and textures can affect adhesion, so test compatibility before completing your project. UV DTF transfers are intended for hard surfaces, not clothing or fabric.

For decorated drinkware, hand washing is recommended. Avoid soaking, dishwashers, and microwaves.

Sublimation

A suitable heat press or sublimation heating setup is required. Follow your blank manufacturer’s recommended time, temperature, and pressure settings for each item.

Sparkle Prints

A heat press is required. Your transfer will arrive printed and cut but not weeded, with a transfer sheet included. Confirm that your garment or fabric is compatible with the transfer and application temperature.

  1. Carefully weed the excess vinyl from around and inside the design.
  2. Place the included transfer sheet over the weeded design and press firmly to ensure the design adheres to the sheet.
  3. Preheat the garment for 2–3 seconds.
  4. Position the masked design on the garment.
  5. Cover with a heat transfer cover sheet.
  6. Press at 311°F / 155°C for 15 seconds using medium to firm pressure.
  7. Peel the carrier hot.

Heat presses may vary. Test your settings before applying the transfer to your final garment or project.